Two-Step Presser Foot Lifter; Attaching The Presser Foot Holder - Silvercrest SNMD 33 B1 Bedienungsanleitung

Two-step presser foot lifter

Attaching the presser foot holder

A
B
1
E
3
E
C
D
a
2
p
4
When sewing thick fabrics, the passage of
fabrics under the presser foot can be
improved by raising the two-step presser
foot lifter (17) further (arrow).
Important:
Turn the main switch (19) to off ("O")
when carrying out all the operations!
1. Install the presser foot holder
Raise the presser bar (A) by lifting the
two-step presser foot lifter (17) Attach
the presser foot holder (B) as illustrated.
2. Inserting the presser foot
Lower the presser foot bar (B) until the
groove (C) is directly above the pin (D).
Lower the presser foot bar (A) as far as it
will go. The presser foot (a) will engage
automatically.
3. Removing the presser foot
Raise the presser foot.
Press the lever (E) gently towards the
front and the presser foot disengages.
4. Inserting the edge/ quilt guide (p)
As shown in the illustration carefully
insert the edge/ quilt guide (p) e.g. For
hems, pleats, etc.
Getting ready
GB / IE 55