Removing/Replacing The Pouring Sieve; Storage - Silvercrest SWKG 3000 A1 Bedienungsanleitung

Removing the lid
To make the cleaning of the appliance interior easier,
you can remove the lid
• Open the lid w .
w
• Press the lid , as shown in the diagramme, to
q
the rear .
• You can then pull out the hinge and lift out the
w
lid , as shown in the diagramme
• On reassembly, ensure that the lid
the correct way round. The thickening at the frame
w
of the lid must point upwards when it is being
replaced, and also the level surface of the frame
to the handle r . Otherwise, the lid
be closed!
q
w
w
:
w
.
w
is put in
w cannot

Removing/replacing the pouring sieve

w
• Open the lid
• Pull the pourer sieve
• Clean the pouring sieve
dishcloth and under running water.
• After cleaning, insert the pouring sieve
above and press it firmly into place. Ensure that
the bar on the pourer sieve
guide rail.
• Should the scale deposits in the pourer sieve
be firmly settled, lay it in a water-vinegar solution,
with a ratio of 6:1, for a few hours. The scale
deposits will dissolve themselves. Rinse the pourer
q
sieve with lots of clear water.

Storage

Allow the appliance to cool off completely before
putting it into storage.
• Wind the power cable
the bottom of the appliance.
• Store the appliance in a dry place.
- 5 -
.
q
upwards out of its holder.
q with a lightly moistened
q
is gripped in the
u
around the holder on
q
from
q