Gastroback 40898 Vital Mixer Basic Bedienungsanleitung Seite 30

Problem
The motor starts stuttering or is too slow.
The motor stops during operation or can not
be turned on again.
The bottom of the glass jug loosens up
during operation; liquid escapes.
You fail to seal the glass jug; liquid escapes
at the bottom of the glass jar.
The appliance does not turn on.
Solution
Turn to the higher speed level. Pour possibly some of the ingredients from the glass jug.
Pound solid ingredients (e.g.: nuts, hard chocolate) outside of the mixer.
Switch off the appliance immediately (turn the ON/OFF switch to position ›0‹), when
the motor stops unexpectedly or is stuck to prevent overheating. Then, check the
following points:
The motor operates only when the glass jug is properly and fully assembled. Make
sure that the glass jug is properly assembled.
Remove the glass jug from the motor base and clear gently with a wooden or
plastic spoon stuck pieces of food on the blade. Apply no violence not to damage
the blades.
Shred hard ingredients (eg nuts, hard chocolate) outside of the mixer. Remove a part
of the ingredients from the glass jug and then try again with a higher speed level.
ATTENTION: Do not overload the motor of the appliance with too hard or too large
ingredients. Do not over load the glass jug. Process solid ingredients possibly in
several steps. The mixer is not suitable for grating of nuts, chocolate or other hard
ingredients.
Switch off the appliance immediately (turn the ON/OFF switch to position ›0‹) and
unplug the power plug from the outlet. Empty the glass jug immediately. Clean and
dry the motor base. If liquids have been spilled into the air vents at the bottom of the
motor base, and have the appliance checked in a specialised service centre.
Make sure that the glass jug is correct and fully assembled according to the instructions
›Assembling the Glass Jug‹.
TIP: Before filling in the ingredients check the tightness of the mixing jar with some water.
Empty the glass jug immediately. Disassemble the glass jug and check the parts for
encrustation or damage (cracks, scratches, cracks, deformation). If necessary, clean
these parts.
Replace damaged parts with original spare parts from the manufacturer. Assemble the
glass jug according to the instructions.
ATTENTION: Never operate the appliance with unsuitable or damaged parts. Use only
parts that are intended and approved by the manufacturer for this purpose. To do so,
contact your dealer.
Check if the glass jug is properly assembled. If the security ring has been applied in the
wrong direction, the appliance cannot be switched on. When the glass jug is assembled
correctly, it engages easily onto the motor base.
30