Getting Ready; Connecting Machine To Power Source; Changing The Bulb - Silvercrest SNM 33 B1 Bedienungs- Und Sicherheitshinweise

Connecting machine to power source

Changing the bulb

B
A
Attention:
Unplug power cord when machine is not
in use.
Attention:
Consult a qualified electrician if in doubt
as to connect machine to power source.
Unplug power cord when machine is not
A A
in use.
The foot control must be used with the
appliance by KD-2902 (220-240V area)
Connect the machine to a power source as
illustrated.
Sewing light
Press main switch (A) for power and light
on. (" l ")
Foot control
Foot control regulates the sewing speed.
Disconnect the machine from the power
supply by removing the plug from the main
socket!
1. Loosen screw (A) as illustrated.
2. Remove the cover (B).
3. Unscrew the bulb and fit new one (C).
4. Replace the cover and tighten screw.
Should there be any problem. Ask your
local dealer for advice.
C

Getting ready

.
GB / IE 9