Fitting The Snap-In Sewing Table; Inserting The Needle - Silvercrest SNM 33 B1 Bedienungs- Und Sicherheitshinweise

Getting ready
Installing the snap-in sewing table

Inserting the needle

C
10 GB / IE
D
A
B
Keep the snap-in sewing table horizontal,
and push it in the direction of the arrow.
The inside of the snap-in sewing table can
be utilized as an accessory box.
Attention:
Turn power switch to off ("O").
Needles must be in perfect condition.
Change the needle regularly, especially if it
is showing signs of wear and causing
problems.
Insert the needle following the illustrated
instructions.
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle.
B. The flat side of the shaft should be
towards the back.
C/D. Insert the needle as far up as it will go.
Only use fully-functional needles:
Problems can occur with:
- Bent needles
- Blunt needles
- Damage points