Getting Ready; Connecting Machine To Power Source; Installing The Snap-In Sewing Table - Silvercrest SNMD 33 A1 Bedienungshinweise Und Sicherheitshinweise

Connecting machine to power source

Installing the snap-in sewing table

Important:
Unplug power cable when machine is
not in use.
Important:
Consult a qualified electrician if in
doubt about connecting the machine
to the power source. Unplug power
20
cable if you are not using the power
supply.
The sewing machine must be used
with the ELECTRONIC foot pedal (r)
FC-2902B (220-240V
Connect the machine to a power source
as illustrated in the adjacent drawing.
Illumination
The machine is started and the light
switched on by pressing the main switch
(20) in position " l ".
Foot pedal
The operating speed of the machine is
regulated with the pedal (r).
If you want to sew on the arm bed, pull
out the snap-in sewing table (9) in the
direction of the arrow.
The inside of the snap-in sewing table (9)
can be utilized as an accessory box.

Getting ready

mains ).
GB / MT 9