Electrolux EHL6740F9K Benutzerinformation Seite 15

Problem
There is no signal when you
touch the panel sensor
fields.
comes on.
comes on.
comes on.
and a number come on. There is an error in the hob. Disconnect the hob from
comes on.
comes on.
Possible cause
The signals are deactivated. Activate the signals.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on
the zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
The cookware does not
cover the cross / square.
The electrical connection is
incorrect. The supply volt-
age is out of range.
There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.
ENGLISH
Remedy
Refer to "Daily use" chapter.
Deactivate the hob and ac-
tivate it again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical informa-
tion" chapter.
Cover the cross / square
fully.
the electrical supply for
some time. Disconnect the
fuse from the electrical sys-
tem of the house. Connect
it again. If comes on
again, speak to an Author-
ised Service Centre.
Speak to a qualified electri-
cian to check the installa-
tion.
Deactivate the hob. Re-
move the hot cookware. Af-
ter approximately 30 sec-
onds, activate the zone
again. If the cookware was
the problem, the error mes-
sage goes out. Residual
heat indicator can stay on.
Let the cookware become
sufficiently cool. Check if
your cookware is compati-
ble with the hob.
Refer to "Hints and tips"
chapter.
15