Sawing Techniques; Sawing Off Small Branches; Sawing Off Larger Branches; Sawing Off Parts - FLORABEST FHE 710 A1 Originalbetriebsanleitung

GB

Sawing techniques

Be thoroughly aware of the danger of rebounding branches.

Sawing Off Small Branches

Set your saw cut of smaller branches (Ø
0-8 cm) from top to bottom, as illustrated.
Be aware of early breaking of the branch
if you have underestimated the size and
weight.
Be completely aware of the falling cut
material

Sawing Off Larger Branches

For controlled sawing of larger branches
(Ø 8-25 cm), first select a relief cut (see
cutting a).
This is made from below.
Saw a notch in the lower third of the
branch.
The actual length cut (see cutting b) is
again made from the top, as far as possi-
ble in line with the first cut so that the two
cuts meet.

Sawing Off Parts

c b a
For large/long branches, sawing off in
parts is recommended (see cutting a, b, c).
This is the only way to safely ensure the
point of impact of the cut material.
Clear away from the area in which you
are standing any parts that have already
been cut and are lying on the ground.
61