WolfVision VZ-C12 Montageanleitung Seite 12

INSTALLATION OF AN EXTERNAL CEILING MOUNT
If the Visualizer needs to be suspended further from the ceiling than with the supplied ceiling mount (in
order to allow greater magnification), a standard ceiling mount or ceiling lift for projectors may be used.
An adapter plate, suitable for weight and screw fittings for the Visualizer, might be necessary.
Fixing the assembly to the ceiling is dependant on the respective construction and desired mounting
location. Ensure that the ceiling construction is able to carry a weight of 80kg (176 pounds) and that
possible collision accidents are prevented.
Important: Please give special attention to the country specific regulations for training and
conferencing rooms! Please give special attention to the country specific regulations for training
and conferencing rooms!
IMPORTANT: Ensure solid mounting and secure connection of all parts to avoid the
G
possibility that the unit detaches itself from the ceiling.
INSTALLATION OF THE VISUALIZER IN A PLENUM BOX
The Ceiling Visualizer can also be installed in a Plenum box which allows the unit to be turned by +/- 45
degrees. To do this, the mounting plate must be installed in the Plenum box in a centred position.
A non-centred position could later prevent the Visualizer from turning or releasing. A Plenum box doesn't
allow a horizontal or vertical movement of the Visualizer. Please follow the instructions outlined on pages
4ff to install the Visualizer in a Plenum box.
INSTALLATION IN A SUSPENDED CEILING OR PLENUM BOX
When the unit is built-in into the ceiling or plenum box, the infrared receivers on the sides are covered. If the
infrared receiver beside the main switch is covered or insufficient, the supplied external infrared receiver
should be connected to the "IR-SENSOR" port.
Alternatively, the unit can be controlled with the RS-232, LAN or USB-port.
11