WolfVision VZ-C12 Montageanleitung Seite 11

The Visualizer can be readjusted if necessary.
By loosening both Allen screws the unit can be turned by 45 degrees to the left or right (please make sure
that both Allen screws are retightened after readjustment). The Visualizer can also be moved backwards or
forwards +/- 30mm (1.18") by loosening the three mounting plate hex nuts on the steel anchors (please
make sure that the mounting plate hex nuts are retightened again after readjustment).
Also, the Visualizer can be moved to the right or left by loosening the six clamping nuts (again, please make
sure that these clamping nuts are retightened afterwards). Two of the six clamping nuts are accessible by
releasing the unit only.
6 clamping nuts
+/- 45°
+/- 30 mm +/- 30 mm
+/- 30 mm +/- 30 mm
stabilization ring with
2 Allen screws
10
3 mounting
plate hex nuts