Abus IPCA Serie Bedienungsanleitung Seite 82

Sensitivity:
Switch time:
Smart IR:
BLC:
WDR:
Wide dynamic level:
HLC:
White balance:
Digital Noise reduction:
Noise reduction level:
Defog:
EIS:
Gray scale:
Mirroring:
Vertical display:
Video standard:
Lens distortion correction:
Local output:
IR LEDs:
Switching threshold: the lower the value, the later the camera
switches to night mode.
delay in seconds until switching to day or night mode.
prevents glare effects from objects that are too close when IR
lighting is enabled.
backlight compensation with reference to a selected area
wide dynamic function for improved display of high contrasts.
The WDR level should be reduced if the image displayed is too
bright.
select the WDR level. A higher level may increase image noise.
High light compensation: Over-exposure around bright spots
will be reduced. A high threshold level stands for high reduction
level. Function only with deactivated WDR.
you can select between different variants of white balance.
function to reduce noise in the image. The higher the value, the
more noise is removed and the more static the image appears.
select the DNR level
This function changes the image contract to better display the
image in the case of fog effects.
(only IPCA72520, IPCA62520)
Electronic image stabilizer to compensate frequent mechanical
influences on the housing (for example by wind at pole
installation)
Setting for full/restricted display of the grey scale area.
this setting can be used to mirror the image horizontally or
horizontally and vertically.
this setting is used to rotate the image to increase the vertical
angle of view. It is necessary to rotate the camera module
through 90° when doing this.
Here you can set the mains frequency of the power supply
network.
Correcting lens distortions by software
Enable/disable the analogue video output.
Enable/disable the infrared LEDs (day & night switching is
retained)
82