InFocus LP 1000 Installationshandbuch Seite 9

Hang the Projector on the Ceiling
1 Loosely install the 12 mm knurled knobs, flat
washers, and conical spacers to the 2 hinge
pins on the base box (Figure 4).
spacer
washer
knurled knob
slide projector
bracket here between
the base box and the knurled knob
Attach knurled knobs to the side of the base box
2 Make sure your cables are pulled through the
center hole of the base box, then carefully lift
the projector and turn it upside down so the
mounting plate faces the ceiling.
3 Insert the projector and mounting bracket
into the base box through the space between
the knurled knobs and base box (Figure 4).
Slide the projector bracket forward until the
knurled knobs rest fully in the vertical slots
and support the projector. Tighten the
knurled knobs completely.
knurled knob
F 4
IGURE
7