Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MAINTENANCE
Changing the Lamp of the Visualizer
1. Remove the power cord of the Visualizer
2. Open the cover screw by using a coin
3. Turn down the lamp incl. lamp cover
4. Change the lamp
Place the new lamp very carefully into the socket
CAUTION: LAMP CAN BE HOT!
5. Mount the lamp cover in reverse order (3 to 1).
Lamp type:
High Frequency Lamp 9W at 10'000 h average burning life.
WolfVision part no. 4656
Cleaning
Cabinet: Clean the cabinet by gently wiping it with a soft, lint freecloth.
Lenses: Clean the lenses by gently wiping with a soft, lint free cloth (do not use a paper
tissue!). Clean by breathing on the lens to create moisture then wipe with lint free
cloth (If need be, use a special optical cleaner only!).
Never use strong cleaning agents such as acetone or benzene!
These substances can damage the surface and the anti-reflex coating!
Infrared Remote Control
Please note that an infrared remote control can only be used up to a certain distance from
the unit. Objects situated between the Visualizer and the infrared remote control, and weak
batteries, interfere with reception.
If the Visualizer can only be controlled from a close
distance, or if it cannot be controlled at all with the
infrared remote control, you may have to change the
batteries.
Open the cover on the back of the remote control
and replace the two 1.5 V AA batteries with new ones.
Check the polarity of the batteries!
Different IR Codes
If you want to work with more than one Visualizer in the same room, the units should be set
to different infrared codes, in order to control them all individually.
To change the IR code, enter the
Code" to A, B, C or D (code A is default). To change the IR code on the remote control,
simultaneously press PRESET 1, PRESET 2
key combination is used, the code switches from A to B, C, D ... A ...in the given order.
For resetting the remote control to code A, simultaneously p
and ZOOM WIDE
.
The LED shows the selected code (it flashes one time for code A, two times for code B,
three times for code C and four times for code D).
on-screen menu, go to
(#33)
15
TELE
1
IMAGE TURN AF
A
EXT / INT
1
4
7
"Misc. Settings" and set the "IR
and ZOOM TELE
(#31). Each time this
ress PRESET 1, PRESET 2
VZ-8plus² only
WIDE
PRESETS
2
3
FOCUS
ALL
IRIS
-
+
MEMORY
2
3
HELP
5
6
8
9
X
+
-
MENU
POWER
front
back (open)
VZ-8plus² only
X
Werbung
Inhaltsverzeichnis
