WolfVision VZ-8plus4 Erste Schritte

Quick Setup Guide - First Steps
Before Starting
Connect power supply and monitor or projector.
Insert both batteries into the remote control - note polarity.
Raise the arm up and turn the camera to working position.
Power Key
Switch the Visualizer on by pressing the POWER key.
Basic Menu Settings
When the Visualizer is switched on the first time, the Quick Setup Guide will be started automatically on-
screen (visible on HDMI and RGB output). Use the arrow keys to navigate through the menu.
Language
Select the desired language for the on-screen menu.
Ethernet Settings
The IP-address, Subnet Mask and Gateway IP-address can be set automatically by a DHCP-server or
manually.
Time Settings
The Visualizer offers the possibility to use the internal clock or an external time server (a time valid time
server IP address and internet connection are required).
Further information is available at
Printed in Austria - October 2012
www.wolfvision.com and on the supplied CD-ROM.
www.wolfvision.com