Replacing The Lamp; Closing The Door - AEG S73200CNS0 Benutzerinformation

Problem
The temperature in the
freezer is too high.
The appliance does not
operate.
The lamp does not work.
If your appliance is still not working properly after making the above checks, contact the
After Sales Centre.

Replacing the lamp

1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Possible cause
Products are too near to each
other.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
What to do if...
Solution
Store products so that there is
cold air circulation.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
1 2
33