Customer Service; Replacing The Lamp - AEG A93200HLW0 Benutzerinformation

Problem
There is too much frost and
ice.
The temperature in the ap-
pliance is too low/too high.

8.2 Customer Service

If your appliance is still not working
properly after making the above checks,
contact the nearest Authorised Service
Centre.
To obtain fast service, it is essential that
when you apply for it you specify the
model and serial number of your
appliance which can be found either on
the guarantee certificate or on the rating
plate located on the external right side
of the appliance.
Possible cause
The lid is not closed proper-
ly.
The lid is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incorrect-
ly.
The temperature regulator is
not set correctly.
The lid is not closed correct-
ly.
The products' temperature
is too high.
Many products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The lid has been opened of-
ten.
Products to be frozen are
placed too closely to each
other.

8.3 Replacing the lamp

1. Disconnect the mains plug from the
mains socket.
2. Replace the used lamp with a new
lamp of the same power and
specifically designed for household
Solution
Check if the lid closes well
and the gaskets are undam-
aged and clean.
Refer to "Opening and clos-
ing the lid".
Position the water drainage
plug in the correct way.
Refer to "Operation" chap-
ter.
Set a higher/lower tempera-
ture.
Refer to "Opening and clos-
ing the lid".
Let the product temperature
decrease to room tempera-
ture before storage.
Store less products at the
same time.
Defrost the appliance.
Open the lid only if necessa-
ry.
Make sure that there is cold
air circulation in the appli-
ance.
WARNING!
Do not remove the lamp
cover at the time of
replacement. Do not
operate the freezer if the
lamp cover is damaged or
missing.
ENGLISH 25