Closing The Door - AEG S73400CNW1 Benutzerhandbuch

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low/high.
If your appliance is still not working prop-
erly after making the above checks, con-
tact the After Sales Centre. You can find
the list at the end of this manual.
REPLACING THE CONTROL
UNIT
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the con-
trol unit. Contact your Service Center.

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper-
ature.
35