Closing The Door; Replacing The Lamp - AEG S83400CTM0 Benutzerinformation

44 www.aeg.com
Problem
The temperature in
the appliance is too
high.
The temperature in
the refrigeration is
too high.
The temperature in
the freezer is too
high.
The appliance does
not operate.
The lamp does not
work.
"dEMo" appears on
the display.
As much as the advice does not lead to result, call the nearest brand-mark service.

CLOSING THE DOOR

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.

REPLACING THE LAMP

The appliance is equipped with a longlife
LED interior light.
Possible cause
The door is not closed cor-
rectly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
Products are too near to
each other.
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The appliance is in dem-
onstration mode.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .
Solution
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Store products so that
there is cold air circulation.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
Close and open the door.
Keep pressed approximate-
ly 10 sec the OK button
since a long sound of buz-
zer is heard and the display
shut off for a short while:
appliance start works regu-
larly.