AEG S83400CTM0 Benutzerinformation Seite 47

A
B
C
1 2
3
2
1
B
C
A
1
2
4
• Remove using a tool the cover (A). Un-
screw the lower hinge pivot (B) and the
spacer (C) and place them on the oppo-
site side.
• Re-insert the cover (A) on the opposite
side.
• Remove the covers (B). Remove the
cover pins (A).
• Unscrew the handles (C) and fix them
on the opposite side.
• Re-insert the cover pins (A) on the op-
posite side.
• Remove using a tool the cover. (1).
• Unscrew the upper hinge pivot (2) and
place it on the opposite side.
• Re-screw the upper hinge.
• Fit the upper door on the upper door
pivot.
• Re-insert the upper door on the middle
hinge pivot (3 )slightly tilting both
doors.
• Re-screw the middle hinge. Do not for-
get the plastic spacer.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabi-
net.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natu-
ral fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The Af-
ter Sales Service specialist will carry out
the reversibility of the doors at your cost.
ENGLISH
47