Fault Indications And Rectification Of Faults - Caso WineSafe 12 black Bedienungsanleitung

15.2 Fault indications and rectification of faults

The following table assists in localizing and rectifying minor faults.
Wine
operate.
Wine refrigerator is not cold
enough.
The light does not work.
Vibrations.
The wine refrigerator seems to
make to much noise
The
properly.
LED could not display.
LED display error - Lo
Bottoms are not functional.
Compressor will not start
Compressor re-start
caso WineSafe 12 black
Fault
refrigerator do not
door will not close
Possible Cause
Not plugged in using different voltage. The
circuit breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a
higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the
correct clearance.
Check the service center.
Check to assure that the wine refrigerator
is level.
The wine refrigerator is not level.
Check the fan.
The wine refrigerator is not level.
The door is reversed and not properly
installed.
The seal is weak.
The shaves out of position.
Main control board does not work.
PCB Problem.
There is some problem with the plug.
Weak quality of display.
Temperature point is out off. Check the
service center.
Temperature controller panel is damaged.
room temperature is lower than desired
temperature.
Compressor will stop working when
cooling system in the cabinet reaches
presetting temperature,
working until the desired temperature is
achieved. Allow a minimum 5 minute
interval before re-starting.
and re-start
36