IKEA Rengöra Handbuch Seite 11

ENGLISH
4
B
If the programme
has a prewash
phase, put a small
quantity of deter-
gent in compart-
ment (B).
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and
the rinse aid dispenser. The rinse aid indi-
cator always comes on if the rinse aid dis-
penser is empty.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use separately
detergent, rinse aid and dishwasher salt,
do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest lev-
el.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
accept some operations.
5
The appliance is in setting mode when, af-
ter the activation, all the programme indi-
cators come on.
If the control panel shows other conditions,
press and hold function buttons (B) and (C)
at the same time until the appliance is in
setting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Press the button of the programme you
want to set.
• The related programme indicator
stays on.
• All the other programme indicators go
off.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again
until the indicator of the number of hours
you want to set comes on. You can set 3,
6 or 9 hours.
• The delay indicator comes on.
3. Close the appliance door. The count-
down starts. When the countdown is
completed, the programme starts.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start
Press and hold function buttons (B) and (C)
at the same time until the delay indicator
goes off and all the programme indicators
come on.
When you cancel a delay start, the ap-
pliance goes back to setting mode.
You have to set the programme again.
11