Installing The Transmitter Batteries; Turn On The Rc System; Binding - Carson X10 Ninja Betriebsanleitung

INSTALLING THE TRANSMITTER BATTERIES

TURN ON THE RC SYSTEM

CAUTION!
Always turn the transmit-
ter´s power switch ON first!
Please change batteries when LED
status flashes on transmitter!!!
1 Connect the rechargeable battery for the driving.
2 Switch on the receiver.
3 Put the body on and fix it with the body split pins.
2
ON OFF

BINDING

Connecting transmitter and receiver:
The vehicle is ready to drive when it leaves the factory. In normal
circumstances, therefore, the binding function is not necessary!
1
ON OFF
Press and hold down the Binding button on
the receiver and then switch on the receiver.
The LED on the receiver then flashes rapidly!
GB // 18
1. Open the battery compartment lid on the underside of the
transmitter.
2. Insert fully charged rechargeable batteries or new AA bat-
teries observing the correct polarity. Close the cover on the
battery compartment again. Ensure that the cover clicks
properly into place. Check that it is in its correct position.
ON
1
ON
The binding function should only be used if there are any connec-
tion problems between the vehicle and the transmitter or if the
transmitter/receiver is replaced.
2
Press and hold down the Binding button
on the transmitter and then switch on the
transmitter.
3
ON OFF
LED
The binding process is completed when
the LED on the receiver is permanently
illuminated.