How To Control Your Model; Servoreverse - Carson Beetle Warrior Bedienungsanleitung

How to controL your moDeL

• Raise the tyres off the ground
• Turn the steering wheel to the right and left as far as it will go. The
wheels are to follow the steering direction.
• If the wheels operate in the opposite direction, operate the servo
Reverse switch (ST in position REV).
• To regulate the driving speed, actuate the throttle/brake
- backwards (forward driving, accelerating) or
- forwards (braking, reversing)
Left
Right

Servoreverse

Setting „REV" (reverse direction of servo rotation). Switch REV or
NOR to the direction of rotation of the gas (TH) or the Steering
channel switch to Normal or Reverse.
Throttle endpoint adjustment (TH.EPA)
The „TH. EPA „adjust the endpoints of the throttle channel. Set the
desired value for the forward (TH.EPA-F) and for reverse (TH.EPA-R)
by using the two knobs.
Dualrate for steering (ST. D/R)
The ST. D/R setting (dual rate steering) increases or reduces the
servo travel in relation to the travel of the steering wheel propor-
tionally over the entire servo path. Rotate ST. D/R to left or right to
change the dual rate setting of the steering.
Trim for throttle and steering
Throttle Trim (TH TRIM): Trim the throttle servo slightly when the
trigger is at the neutral position.
Steering Trim (ST TRIM): If the front wheels do not align straight, use
the steering trim to adjust.
Neutral
Left
braking, reverse
movement
driving forward,
to give speed
19 // GB
Right