Connection Between Devices; Operation; Stand Alone-Mode - EuroLite LED PMC-8x30WCOB RGB MFL Bedienungsanleitung

The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.

Connection between devices

On the rear panel, there is a Neutrik PowerCon socket (Power Out). Connect the output with the input of the
next fixture until all fixtures are connected.
Please note: A maximum of 8 EUROLITE LED PMC-8x30W COB RGB MFL devices may be linked
together. After every 8 devices, the fixtures must have a renewed connection with the power mains.

OPERATION

After you connected the LED PMC-8x30W COB RGB MFL to the mains, it starts running.
The LCD display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
The device has two operating modes. It can be operated in Stand Alone mode via LCD display with
operating buttons or in DMX-controlled mode via a lighting controller.

- STAND ALONE-MODE

• Solid colors/Internal programs
• Auto Mode
• Master/Slave Mode
• Sound Mode
• Dimmer speed
• RDM
• White balance
- DMX MODE
STAND ALONE-MODE
Solid colors / Internal programs
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
the LED PMC-8x30W COB RGB MFL, you can select up to 13 different chasers plus solid colors.
Setting colors:
Press the MODE button until the display shows 1. STATC. Press the ENTER button. You can select the
colors via the UP or DOWN button.
Press the ENTER button to select the flash setting, respectively. You can select the desired value (from 00
to 99, increasing) via the UP or DOWN button.
Selecting a chaser
Press the MODE button to select the internal program mode. Select the desired chaser (P02 – P14) via the
UP or DOWN buttons (see following graphic).
Press the ENTER button to select speed (SP) and flash (F) settings, respectively. You can select the desired
values via the UP or DOWN buttons.
Speed (SP) from 00 to 99, increasing.
Flash (F) from 00 to 99, increasing.
25/32 00080137.DOC, Version 1.0