Dmx-Protocol - EuroLite LED TMH-9 Bedienungsanleitung

- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

4 DMX channel mode
Control-channel 1- Horizontal movement (PAN)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 2 - Vertical movement (TILT)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 3 - Color macros
Decimal Hexad. Percentage S/F
0 15 00 0F 0% 6%
16 31 10 1F 6% 12%
32 47 20 2F 13% 18%
48 63 30 3F 19% 25%
64 79 40 4F 25% 31%
80 95 50 5F 31% 37%
96 111 60 6F 38% 44%
112 127 70 7F 44% 50%
128 143 80 8F 50% 56%
144 159 90 9F 56% 62%
160 175 A0 AF 63% 69%
176 191 B0 BF 69% 75%
192 207 C0 CF 75% 81%
208 223 D0 DF 82% 87%
224 239 E0 EF 88% 94%
240 255 F0 FF 94% 100%
Control-channel 4 - Switching the LEDs, Strobe, Reset
Decimal Hexad. Percentage S/F
0 20 00 14 0% 8%
21 30 15 1E 8% 12%
31 200 1F C8 12% 78%
201 250 C9 FA 79% 98%
251 255 FB FF 98% 100%
S Blackout
S Red
S Green
S Blue
S White
S Red/green
S Red/blue
S Red/white
S Green/blue
S Green/white
S Blue/white
S Red/green/blue
S Red/geen/white
S Green/blue/white
S Blue/red/white
S Red/blue/geen/white
S Neutral
S Reset
F Strobe-effect with increasing speed
F Random strobe-effect with increasing speed
S Open
25/30
Feature
Feature
00066323.DOC, Version 1.0