Inhaltsverzeichnis
Werbung
en
Switching on
the appliance
Switch on the appliance with the main
switch. Fig. 1/8
The temperature warning noise is
switched off by pressing the Alarm button.
Fig. 2/1
The temperature displays flash and
the Alarm button display is lit up,
until the appliance has reached the set
temperatures.
Interior light in refrigerator compartment
is switched on when the door is open.
The factory has recommended the
following temperatures:
Refrigerator compartment:
Cool fresh compartment:
Freezer compartment:
Operating tips
S While the refrigerating unit is running,
beads of water or hoarfrost form at the
back of the refrigerator compartment.
This is quite normal. It is not necessary
to scrape off the frost or wipe off the
beads of water. The rear panel defrosts
automatically. The condensation flows
into the evaporation area of the
appliance via the condensation
channels and the drainage hole.
S The fully automatic Nofrost system
ensures that the freezer and refrigerator
compartments remain free of ice.
Defrosting is not required.
28
+4 °C
at almost 0 °C
-18 °C
S The sides of the housing are sometimes
heated slightly. This prevents conden
sation in the area of the door seal.
S If you cannot open the freezer compart
ment door immediately after closing it,
wait 2-3 minutes until the partial vacuum
has equalised.
Selecting
the temperature
Fig. 2
Refrigerator compartment
(can be selected from +2 °C to +8 °C).
Keep pressing temperature selection
button 6 until the required refrigerator
compartment temperature is set.
The value last selected is stored.
The set temperature is indicated on
display 7.
We recommend a setting of +4 °C.
Perishable food should not be stored
warmer than +4 °C.
Cool fresh compartment
The temperature in the cool fresh"
compartment, Fig 1/B, has been set to
almost 0 °C at the factory and should not
be changed if at all possible. If frost forms
on the refrigerated food, the temperature
can be increased. (See Eliminating minor
faults yourself".)
Werbung
Inhaltsverzeichnis
