Inhaltsverzeichnis
Werbung
en
Fault
Appliance is not cooling,
temperature display
lamps and interior light
are lit.
The interior light is not
The interior light is not
functioning.
functioning.
Temperature display
lights are flashing.
Fig. 2/4 or Fig. 2/7
Warning signal sounds
and the temperature
display lamp is flashing.
Fig. 2/4
The temperature
in the cool fresh"
compartment is too cold
or too warm.
40
Possible cause
Showroom mode is switched on.
The LED light is defective.
Door was open too long.
Light switches off after
approx. 10 min.
Appliance door opened frequently.
A lot of food was placed in
the freezer.
Fault
the freezer compartment
is too warm!
Frozen food is at risk!
The fixed setting has been set too
high or too low (e.g. if there is frost
in the cool fresh" compartment).
Remedial action
Hold down Alarm button, Fig. 2/1,
for 10 seconds until an
acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
See chapter Light (LED)" section.
When the door is closed and
opened, the light is on again.
Do not open the door unnecessarily.
Switch on super freeze before
inserting the food.
See chapter entitled Warning
signal".
The temperature in the cool fresh"
compartment can be changed to be
2 steps warmer and/or colder.
If the bargraph is set to 4,
the cool fresh" compartment has
a temperature of almost 0 °C.
The numbers on the bargraph do
not correspond to the cool fresh"
compartment temperatures.
Step 2 - coldest setting
Step 8 - warmest setting
Press button, Fig. 2/2, for
3 seconds until a beeping signal
sounds, the display 4 flickers.
Change the setting with button 3.
After one minute, the set
temperature is stored.
Werbung
Inhaltsverzeichnis
