Hookswitch Selection; Range/Power Selection - Jabra GN9350e Handbuch

Important: For USB applications, the volume settings are fixed and need no adjustment.

2.4.2 Hookswitch selection

The GN9350e enables you to answer and end calls remotely by using the GN1000 RHL, or its
built-in electronic hookswitch (EHS) modes. EHS is only possible on certain telephone sys-
tems. In order to determine which telephones have the EHS feature enabled, please refer to our
website www.jabra.com. Please also refer to your telephone´s user manual for clarification.
4 modes are available
GN RHL
DHSG
AEI
MSH
Note: By default, the GN9350e is set to the RHL interface, which also is
the correct setting if you manually operate your handset when answering/ending calls as described in
the Guide for basic set-up and use.
To select the appropriate interface:
3 4
1. Use to locate the hookswitch selection menu
on base display.
5 6
2. Use to select one of the 4 interfaces from the menu.
3. Press OK to confirm the interface.
Note: To use the DHSG, AEI or MSH function, connect the connec-
tion cord (accessory) to your desk telephone and the AUX port of
the GN9350e.

2.4.3 Range/power selection

Your headset offers 3 range/power modes (Normal, Low and Very Low). The Normal mode
is ideal for most users. However, if you experience interference from other communication
devices during your calls, you may want to switch to the Low or Very Low modes. Changing to
Low or Very Low power modes will reduce the range of your headset.
81-02622_RevB_GN9300e_UM_RBIII.indd 6
non-EHS; works with the GN1000 RHL
e.g. Siemens and Elmeg desk telephones
e.g. with Tenovis desk telephones
e.g. with Alcatel desk telephones
6
17-09-2008 13:35:22