Lcd Display; Changing The Settings; Transmit Volume - Jabra GN9350e Handbuch

GN9350e GN9330e

2.4 LCD display

Your base unit has a LCD display and display control with which you control 5 settings:
Transmit volume setting
Hookswitch selection
Range/power selection
Sound mode selection
Protection level selection (IntelliTone
Navigation and markers
Navigate through the LCD display's 5 menus horizontally using the display control's
rows. Within each of the 5 menus, navigate vertically with the display control's
Press the OK button to confirm a specific choice/value within the 5 different menus. A star (*)
beside a selected choice/value indicates the current setting.
Default/start position
The LCD display is always on and ready to use. The permanent default/start position for the
LCD display is the leftmost transmit volume setting
this default/start position, if not operated for 30 seconds.
Within each of the 5 menus, there is also a factory-set default. This default remains until you
change it. The last selected choice/value (within each of the 5 menus) is always displayed in
the first line of its menu.

Changing the settings

2.4.1 Transmit volume

The transmit volume must be adjusted properly so your voice is heard clearly.
If you haven't already adjusted the transmit volume during your initial setting up, do so now
by completing the following:
1. Put on headset.
3 4
2. Use to locate transmit volume menu
3. Make a call to someone who will act as a test person.
5 6
4. Use to scroll through 12-setting transmit volume menu
confirms your voice is at the appropriate volume.
5. Press OK to confirm new setting.
The transmit volume menu is the permanent default/start position for the LCD display. After
adjusting any of the other settings via the display, it will revert to the transmit volume menu
position.
81-02622_RevB_GN9300e_UM_RBIII.indd 5
GN9330e USB
®
)
5
. The LCD display will always revert to
on base display.
until your test person
3 4
ar-
5 6
arrows.
17-09-2008 13:35:22