Switching A Call From Desk Telephone Handset To Headset; New Master Headset Pairing To Base - Jabra GN9350e Handbuch

• Press the headset's talk button.
• Press the base's telephone mode button.
–> The headset's link indicator will stop flashing to indicate that the headset-base link
has been closed.
Important: If using electronic hookswitch on your telephone, do not place the headset into
the charging cradle, and do not press the headset´s talk button or press the base´s telephone
mode button, as this will disconnect the call.
If the headset runs out of battery power, the headset-base link will remain active for up to 2
minutes to allow for battery changing.
GN9350e GN9330e

4.6 Switching a call from desk telephone handset to headset

It's possible to switch a call in progress from the telephone's handset to the headset:
1. Remove the headset from base, or if already out, press
the headset's talk button. This establishes a link.
–> The headset's link indicator will start flashing and the
call will be switched to the headset.
Note: Do not place handset before the call is over, as this will end the call.
GN9350e GN9330e

4.7 New master headset pairing to base

You may designate a new master headset for your base.
Important: Before designating a new master headset, ensure
that the original headset's link to the base unit is closed by
pressing its talk button. The telephone or USB indicator should
not flash.
To designate a new master headset:
1. Place the new master headset into the charging cradle of
the base.
2. Press the base's pairing button.
–> Both the telephone and USB mode buttons on the
base, and the headset's link indicator, will light for 2 sec-
onds. This indicates successful pairing of the new master
headset.
81-02622_RevB_GN9300e_UM_RBIII.indd 13
GN9330e USB
GN9330e USB
13
1
2
17-09-2008 13:35:23