Cleaning And Maintenance - EuroLite BE-200 Barrel Effect Bedienungsanleitung

Manual Control
Manual DMX
With this function, you can adjust each channel manually.
Fix Position
With this function, you can calibrate and adjust the effect wheels to their correct positions. The password for
this function is „050".
Internal program
With this function, you can run the internal program. The selection "Alone" means Stand Alone-mode and
"Master" that the device is defined as master.

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
The interior of the device should be cleaned at least annually using a vacuum-cleaner or an air-jet.
There are no serviceable parts inside the device except for the lamp and the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamps".
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
35/36
00088759, Version 1.0