Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replacing the fuse
If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
DMX control channels:
DMX512 connection:
Sound-control:
Flash-rate:
Color wheel:
Static gobo wheel:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T
Maximum housing temperature T
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
OSD 5 Reflector 200W discharge lamp
MSD Platinum 5R discharge lamp
TPC-10 Coupler, silver
AG-15 4x1000mm Safety bond up to 15kg
XLR cable 3pin 3m bk
XLR plug 3pin 110 Ohm
Please note: Every information is subject to change without prior notice. 11.12.2014 ©
100-240 V AC, 50/60 Hz ~
275 W
8
3-pin XLR
via built-in microphone
1-13 Hz
13 dichroic plus white
14 gobos and open
430 x 230 x 320 mm
6.5 kg
:
45° C
a
(steady state):
50° C
C
0.5 m
0.5 m
T 3 A, 250 V
No. 89101925
No. 89101930
No. 59006856
No. 58010364
No. 3022047N
No. 30208430
36/36
00088759, Version 1.0
Werbung
Inhaltsverzeichnis
