Cleaning, Maintenance And Storing - MIA IKP 2210 Bedienungsanleitung

If the product operating in abnormal conditions, E0, E1, E2, E3, E4, E5, and E 6
will be displayed and for safety reasons the appliance stopp heating. Refer to
below grid for solution.
error Reason:
code
E0 no adequate cookware
found
E1 Inner temperature sensor
failed
E2 sensor for panel failed
E3 Overvoltage, the voltage of
power is source over than
270V
E4 Low voltage, the voltage of
power source lower than
140V
E5 Panel overheat
E6 Panel overheat
Attention: After use and when the cooking or warming process is finished always switch OFF and
unplug the appliance.

Cleaning, maintenance and storing

Caution danger of burning and electric shock! Always switch off and unplug your appliance after
use and before cleaning. Let the appliance cool down before cleaning and storage. Never
immerse the appliance in water or clean it under running water.
Wipe the plates and stainless steel surface with a damp cloth only.
Clean the device after each use to remove food residues.
Wipe off the glass plate and the plastic surfaces with a slightly damp cloth.
Make sure that no water can come into the device.
To avoid any danger or risk of electrical shock, never immerse the device or the cord into water or
any other liquid. Do not put the device and the cord into the dishwasher!
To avoid damaging the surface of the unit never use abrasive cleaners, cleaning pads or any sharp
objects (i.e. metal scouring pads). If using metal objects to clean, the sensitive surface can be
damaged easily by scratches. Always handle the appliance with care and without any force.
Use of additional cleaning liquids is recommended for induction cooking-plates to extend their lifetime.
Do not use any petrol products to clean the device to avoid damaging the plastic parts and the
control panel.
Do not use any flammable acidy or alkaline materials or substances near the device, as this may
reduce the service life of the device and cause deflagration when the device is switched on.
Make sure that the bottom of the cookware does not scrap across the glass field.
Solution:
Ensure that the cookware is made of ferromagnetic steel (or
bottom suitable for induction cooker), and the diameter of
bottom must larger than 12cm.
Contact qualified person for repair
Contact qualified person for repair
Switch off until power source is stable (standard voltage should
be 220 - 240V).
Switch off until power source is stable (standard voltage should
be 220 - 240V).
stop the product until the product cooled down, then you can
restart it again.
to cool down the machine, and ensure the air intake or
ventilation port is not blocked. If such issue occur again, contact
qualified person for repair.
19