Herunterladen Inhalt Inhalt Diese Seite drucken

Tunze Comline Serie: 3166 Gebrauchsanleitung Seite 35

Filter und bio-hydro-reactor
Vorschau ausblenden Andere Handbücher für Comline Serie: 3166:
Inhaltsverzeichnis

Werbung

Fill water into the tank up to the height of the
surface suction device (5). Remove the filter bell
from Comline filter (6). When the water level in the
Comline filter reaches the infrared sensor of the
Osmolator, stop filling water into the aquarium.
Fill the filter bell with aquarium water and place in
the mechanical filter. Fill two-thirds of the storage
container (7) with water, reverse osmosis water is
ideal.
Switch the filter pump on; the water level in the
Comline filter will drop. Start up the Osmolator; for
this purpose, plug the power supply unit (8) into the
socket and check whether replenishment water is
filled into the aquarium (9). The metering pump (10)
compensates the existing difference in water level.
If the shortage is too big, the Osmolator will stop
after eight to ten minutes and will report a failure.
Subsequently, reset Controller 5017 (11) by briefly
unplugging the power supply unit (8).
The upper safety sensor (12) of the Osmolator must
not cause an alarm when the maximum water level
is reached.
Remplissez
l'aquarium
superficielle (5) puis retirez la cloche de filtration
rapide (6). Le remplissage peut être arrêté lorsque
le niveau dans le filtre atteint le capteur infrarouge.
Remplissez la cloche de filtration avec l'eau de
l'aquarium puis insérez-la dans le compartiment de
filtre.
Remplissez le réservoir (7) à 2/3 d'eau douce,
idéalement de l'eau osmosée.
Enclenchez la pompe de filtration : le niveau
d'eau dans le compartiment de filtration s'abaisse.
Branchez l'alimentation électrique (8) de l'Osmolator
et vérifiez si l'eau est bien amenée à l'aquarium par
le tuyau (9). La pompe de dosage (10) compense la
différence de niveau dans le filtre. Si cette différence
devait être trop importante, la surveillance du temps
de dosage arrêterait la pompe après 8 – 10 min
avec une signalisation de défaut. Pour effectuer un
RESET de la fonction, débranchez puis rebranchez
l'alimentation secteur (8) sur le Controller 5017 (11).
Le niveau d'eau maximal dans l'aquarium ne
doit pas déclencher une alarme du capteur de
sécurité (12).
jusqu'à
l'aspiration
35

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

3166.503167.50316731793166

Inhaltsverzeichnis