Herunterladen Inhalt Inhalt Diese Seite drucken

Tunze Comline Serie: 3166 Gebrauchsanleitung Seite 31

Filter und bio-hydro-reactor
Vorschau ausblenden Andere Handbücher für Comline Serie: 3166:
Inhaltsverzeichnis

Werbung

Place the Comline to the horizontal pane
using the pre-mounted holder as shown on
the Reefpack.
Use the mounted holder with sliding unit "r" for
the right-hand side (sliding unit "l" for the left-hand
side), and continue as already described for vertical
attachment (11).
Use the fully assembled holder (holder and clamping
unit) to attach the Comline (shown by the example
of Reefpack 505) on the glass pane, and then lift
the Reefpack with holders (12) off the clamping
unit (13).
Now tighten the clamping screws (2), re-suspend
the Reefpack and attach with the screws (3).
If and when required, the mounting height of the
Reefpack can be set by means of the sliding units,
which requires that the holder is dismounted again;
subsequently lift the bracket, move it and permit it
to snap in.
When used as an individual unit, Filter 3166/3167
has to be stabilised by using two screws M6 x 16
mm (.62 in.)(14). The unit is mounted on the rail
already placed on the rear side of the Comline filter.
Mise en place support Comline sur vitre
horizontale avec support préalablement
monté, illustré par Reefpack
Utilisez les supports montés avec pièce coulissante
« r » pour le côté droit et « l » pour le côté gauche
puis assemblez le tout comme décrit dans le
montage pour vitre verticale (11).
Fixez légèrement l'élément Comline et ses différentes
pièces de support totalement montées (rail et pince
de serrage) sur la vitre puis désolidarisez l'élément
Comline et son support (12) de l'attache (13).
Serrez fortement les vis de blocage (2) puis insérez
à nouveau l'élément Comline en le fixant solidement
à l'aide des vis (3).
La position de fonctionnement du Reefpack peut
être facilement réajustée. Pour cela, démontez
les supports, libérez le verrouillage des pièces
coulissantes puis faites glisser sur le rail jusqu'à la
position souhaitée.
Utilisés seuls, les filtres Comline 3166/3167
nécessitent de plus 2 vis M6 x 16mm (14) pour
assurer leur stabilité. Les deux rails de support se
trouvent ainsi complètement solidaires à l'élément
Comline.
31

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

3166.503167.50316731793166

Inhaltsverzeichnis