Herunterladen Inhalt Inhalt Diese Seite drucken

Tunze Comline Serie: 3166 Gebrauchsanleitung Seite 25

Filter und bio-hydro-reactor
Vorschau ausblenden Andere Handbücher für Comline Serie: 3166:
Inhaltsverzeichnis

Werbung

Attach the Comline to the vertical pane using
the pre-mounted holder as shown in Comline
Reefpack.
Use the mounted holder with sliding unit "r" for the
right-hand side (sliding unit "l" for the left-hand side).
As shown in Fig. (7), place A and B in the Comline,
and subsequently swivel into vertical position as
shown in Comline Reefpack. For this purpose, use
holder with sliding unit (5) for the filter element, and
holder with sliding unit (6) for the skimmer. Press
the suction unit (8) into the lower nipple. Suspend
Comline Reefpack over the glass edge and tighten
the clamping screws (2).
If and when required, the working position of the
Reefpack can be set by means of the sliding units,
which requires that the holder is dismounted again;
subsequently lift the bracket, move it and permit it
to snap in.
When used as an individual unit, Filter 3166/3167
has to be stabilised by using two screws M6 x 16
mm (.62 in.)(9). The unit is mounted on the rail
already placed on the rear side of the Comline filter.
Mise en place Comline sur vitre verticale avec
support préalablement monté, illustré par
Reefpack
Utilisez les supports montés avec pièce coulissante
« r » pour le côté droit et « l » pour le côté gauche.
Comme sur l'encadré (7), insérez la pièce
coulissante dans les points A et B puis positionnéz
verticalement le support (indiqué sur schéma
principal). Utilisez la pièce coulissante (5) côté
filtre et (6) côté écumeur. Insérez la ventouse (8) en
partie inférieure. Positionnez Comline Reefpack sur
une vitre verticale puis serrez la vis de blocage (2).
La position de fonctionnement du Reefpack peut
être facilement réajustée. Pour cela, démontez
les supports, libérez le verrouillage des pièces
coulissantes puis faites glisser sur le rail jusqu'à la
position souhaitée.
Remarque : utilisés seuls, les filtres Comline
3166/3167 nécessitent encore 2 vis supplémentaires
M6 x 16mm (9) pour assurer leur stabilité. Les deux
rails de support se trouvent ainsi complètement
solidaires à l'élément Comline.
25

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

3166.503167.50316731793166

Inhaltsverzeichnis