Silvercrest 116072 Bedienungsanleitung Seite 10

SilverCrest SMRS 35 A1

if the power adapter is damaged

if the power adapter has been exposed to rain, liquids or high levels of humidity

before a prolonged absence, e.g. holiday

when you wish to clean it

The power adapter consumes electricity even in Standby mode. In order to completely
disconnect the device from the mains, the power adapter must be pulled out from the power
socket.
Please follow these instructions to avoid risk of potential fatal injury or fire! Never cover the power
adapter, otherwise there is a risk of fire. Do not attempt to open the housing of the power adapter.
This could result in potentially fatal electrocution.
WARNING! Cables
Unplug all cables by holding the plugs and never pull on the cables themselves. Never place
pieces of furniture or other heavy objects on the cables and take care that they do not become
damaged, especially at the plugs and sockets. Never install the cable around hot or sharp objects
to avoid damaging it. Never tie knots in cables and do not tie them to other cables. All cables
should be positioned so that nobody can trip over them or be obstructed by them.
DANGER! Radio interface
Turn the device off when on board an aircraft, in a hospital, in an operating theatre or in the vicinity
of electronic medical equipment. The RF signals may interfere with the functionality of sensitive
devices. Keep the device at least 20 cm (8 inches) away from pacemakers, as the RF signals could
interfere with the functionality of the pacemaker. The RF signals transmitted can interfere with
hearing aids. If the wireless mode is switched on, do not place the device near flammable gases or
in a potentially explosive area (e.g. a paint shop), as the RF signals transmitted could cause
explosions or fire. The range of the radio frequency signals depends on environmental conditions. If
data is transmitted via a wireless connection, it can also be received by unauthorised parties. Targa
GmbH is not liable for any interference caused to RF or TV signals through unauthorised
modification to this device. Furthermore, Targa accepts no liability for replacing any cables or
devices that have not been specifically approved by Targa GmbH. The user is solely responsible
and liable for remedying any interference caused by such unauthorised modification of this device
and for replacing appliances.
Servicing / Repair
Repairs are required if this device is damaged in any way, for example, if the power adapter or
device housing is damaged, if liquids or objects have entered the device or if the product has been
8 - English