Equalization; Raising Or Lowering The Bass Section - Adam Tensor Center Bedienungsanleitung

4. Speaker Adjustment
4.8

Equalization

The charts on the right illustrate the individual settings
of the equalizer: 'Gain' means the sound pressure
(volume), 'Q' (for Quality) representing the effective
width and 'Freq' the particular frequency.
In case a problem like 'standing waves' occur, please
proceed as follows:
• Lower the ‚Gain' by -6 dB.
• Set ‚Q' to 4.
• Now, slowly change the frequency (‚Freq.') within 20 to
100 Hz until the distortion is no more audible.
4.9

Raising or lowering the bass section

If you wish to either raise or lower the bass frequencies, the parametric
equalizer is the best tool.
For a moderate bass boost the following settings are recommended:
• 'Gain' +3dB
• 'Q' -0.5
• 'Freq.' 40Hz.
For a lowering of the bass section these settings are recommended:
• 'Gain' -3dB
• 'Q' -0.5
• 'Freq.' 40Hz.
Please note: 'Gain' is the parameter that controls how much effect the
settings of the parametric EQ have on the overall sound.
Tensor Center (Semi-active Version) Manual
Gain
Q (Quality)
Freq. (Frequency)
moderate boost of low frequencies
moderate lowering of the bass frequencies
/ english
11