Downmixing Mode - Samsung STB-E7500 Handbuch

Audio
Dynamic Range Control

Downmixing Mode

Audio Sync
Connected Device
Set Dynamic Range Control option for Dolby Digital and
Dolby Digital Plus.
 Off : You can enjoy original sound without
compressing Dynamic Range of the sound.
 On : The Dynamic Range is compressed appropriately
by boosting low level sound and reducing extremely
loud sound.
| NOTE |
\ This Setting is not applied to HDMI and Optical output in
case of "Digital Output" setting is "Bitstream(Unprocessed)"
and the "Audio Description" is set to "Off".
\ This Setting is not applied when you are watching DTV
Program.
Select Downmix method for stereo output.
In some cases when the product is connected to a
digital TV, the audio signal may not synchronize with the
video signal. If this occurs, adjust the audio delay time
to match the video signal.
• You can set the audio delay time between 0 msec
and 200 msec.
Adjust it to the optimal setting.
| NOTE |
\ The audio delay time you specify may not be exact depending
on the played content.
Choose an equipment that you have connected to this
product to hear the sound in addition to your TV.
Loudness of DTV Program will be adjusted according to
your equipment.
 AV Receiver : Select this If you use a general AV
Receiver / Home Theatre Equipment or a Television to
hear sound.
 AV Receiver (Offset Mode) : Slect this if your case is
one of two shown below.
- If you use THX Certified AV Receiver / Home
Theatre Equipment.
- In case "Digital Output" is set to "Bitstream",
and If you feel the the Dolby Audio much louder
than MPEG1 Layer2 Audio while watching DTV
Program, select this even if your AV Receiver is
not THX Certified one.
 Stereo Device : Select this if you use a Stereo
Amplifier or Recording Device that support Optical
Digital Audio Input as PCM format.
23
|
English