Herunterladen Inhalt Inhalt Diese Seite drucken

Contrôleur Ph/Co2 7074/2 En Régulation - Tunze 7074/2 Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Using pH / CO2 controller set
7074 / 2 as a control station
First of all please observe all notes on the use of the
measuring instrument 7070/2 rendered in the previous
chapters. Apart from the pH / CO2 controller set 7074/2,
the following units are required:
A CO2 reactor (cf. TUNZE reactors).
A pressure regulator with fine adjustment (7077/2).
CO2 cylinder (7079.15 or 7079.20).
Connect the parts of the control station electrically (1).
Do not use a battery! The controller is powered by the
solenoid connection. use of a battery in addition could
damage the controller or result in the battery leaking.
Use the 4x1 mm CO2 hose supplied along with the unit
to link the various components:
The pressure regulator is screwed onto the CO2
cylinder (cf. Instructions of the pressure regulator).
Use the CO2 hose to link the outlet of the pressure
regulator with the inlet of the CO2 metering valve (2).
Use the CO2 hose to link the output of the CO2 metering
valve (5) with the inlet of the non-return valve (3).
Use the CO2 hose to link the output of the non-return
valve (4) with the input of the bubble counter with leads
to the CO2 reactor.
Set contrôleur pH/CO2 7074/2 en régulation
Veuillez
observer
chapitres précédents concernant le contrôleur
7070/2. En plus du Set contrôleur pH/CO2 7074/2,
les articles suivants sont nécessaires :
Réacteur CO2 (voir réacteurs TUNZE®).
Réducteur de pression à réglage fin (7077/2).
Bouteille CO2 (bouteille 7079.15 ou 7079.20).
Raccordez électriquement les différents éléments
de la station de régulation (1). Aucune batterie ne
doit se trouver dans le logement du contrôleur,
risque de coulure !
A l'aide du tuyau CO2 4X1mm livré, raccordez les
différents composants comme suit :
Vissez le réducteur de pression sur la bouteille
CO2(voir notice du réducteur).
Raccordez la sortie du réducteur de pression sur
l'entrée de l'électrovanne CO2(2).
Raccordez la sortie de l'électrovanne CO2(5) sur
l'entrée du clapet anti-retour (3).
Raccordez la sortie du clapet anti-retour (4) sur
l'entrée du compte-bulles conduisant ensuite au
réacteur.
les
recommandations
des
35

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

7070/27075/27071/2

Inhaltsverzeichnis