Operating Elements And Connections - Monacor AV-200SET Bedienungsanleitung

Please unfold page 5. Then you can always see the
operating elements and connections described.
Contents
1

Operating Elements and Connections . . . 9

1.1 Connections of the transmitter station and
the receiver station . . . . . . . . . . . . . . . . . . . . 9
1.2 Bottom side of the receiver station . . . . . . . . 9
1.3 Channel switches of the transmitter station . . 9
2 Safety Notes . . . . . . . . . . . . . . . . . . . . . . . . 10
3 Applications . . . . . . . . . . . . . . . . . . . . . . . . 10
3.1 Approval . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
4 Setting into Operation . . . . . . . . . . . . . . . . 10
4.1 Placing the transmitter station and
the receiver station . . . . . . . . . . . . . . . . . . . 10
4.2 Channel selection . . . . . . . . . . . . . . . . . . . . 10
4.3 Connecting the units . . . . . . . . . . . . . . . . . . 10
4.4 Correcting the video level . . . . . . . . . . . . . . 11
5 Extension facilities . . . . . . . . . . . . . . . . . . . . 11
6 Specifications . . . . . . . . . . . . . . . . . . . . . . 11
1 Operating Elements and Connections
1.1 Connections of the transmitter station and
the receiver station (fig. 1)
1 Antenna (do not scratch or break off)
2 DIN AV jack, pin configuration (fig. 2):
1 not connected
2 video signal
3 ground
4 audio, left
5 output supply voltage +5 V, max. 80 mA, for ad-
ditional units, e. g. RF modulator
6 audio, right (for stereo only, with the receiver
AV-100R this contact is not connected)
3 Low voltage jack for voltage supply
the transmitters requires 12 V /150 mA,
the receiver requires 8 – 10 V /320 mA;
centre contact = positive pole;
required low voltage plug 5.5/2.1 mm
(outside/inside diameter)
1.2 Bottom side of the receiver station (fig. 3)
4 Trimming control* to correct the video level if the
picture of the reproduction unit (e. g. TV set, video
recorder) is too bright or too dark
5 Switch* for the transmission channel; factory-set
to channel 1
* To operate the control or the switch, pierce the small circle
of the label with a screw driver. Make the adjustment by
means of the screw driver.
1.3 Channel switches of the transmitter station
(fig. 4)
The transmitter station is factory-set to channel 1. To
switch to another channel, screw off the lower
housing shell of the unit. Adjust the DIP switches to
the desired channel according to fig. 4.
9