Operating Elements And Connections; Safety Notes - Monacor KA-10/1PACK Bedienungsanleitung

All operating elements and connections de -
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1.1 Transmitter and receiver
1 3.5 mm jack
on the transmitter: as an audio output to connect
the supplied tie clip microphone or an audio
unit with line output (CD / MP3 player, radio,
mixer etc.)
on the receiver: as an audio output to connect the
following unit (camera, amplifier, mixer etc.)
2 RESET button
3 On / off button
To switch on, briefly press the button; to switch
off, keep the button pressed for 3 seconds until
the power LED (4) is extinguished
4 Power LED
green = battery charged sufficiently
red = battery discharged
5 Clip
6 on the back
of the transmitter: control GAIN for the volume
of the audio signal transmitted
of the receiver: rotary switch PAD for the output
level of the jack AF OUT (1)
7 Display, to indicate the transmission channel
To illuminate the display for a few seconds,
press the button POWER (3) or CHANNEL (8)
briefly.
8 Button CHANNEL to set the transmission chan-
nel
9 Microphone in the transmitter
10 Adjusting key
11 Shoe mount adapter, held in place by the clip (5)
1.2 Charger
12 Jack to connect the power supply unit provided
13 Charging slot
14 Charging LED
8
POWER

2 Safety Notes

The units (transmitter, receiver, charger and power
supply unit) correspond to all relevant directives of
the EU and are therefore marked with
WARNING
The power supply unit uses danger-
ous mains voltage. Leave servicing
to skilled personnel only. Inexpert
handling may result in electric shock.
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range: 0 – 40 °C).
G
Do not operate the charger and immediately dis-
connect the power supply unit from the socket
1. if the units are visibly damaged,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled
personnel.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they
are not correctly connected or operated, or if they
are not repaired in an expert way.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.
3 Applications
This audio transmission system can be used to
replace the connection cable between a micro-
phone and a video camera. The transmitter sends a
wireless microphone signal to the receiver. The user
of the video camera is free to move as desired with-
out being restricted by a cable. Instead of the sup-
plied transmitter, it is also possible to use the wire-
less microphone KA-8TH /1 (order no. 25.4410).
The system KA-10 /1PACK is also suitable for wire-
less transmission of line audio signals.
.