Monitoring Functions; Battery Monitor / Emergency-On Mode; Troubleshooting; Technical Data - Truma Vicon 2 Gebrauchsanweisung

Monitoring functions

The Vicon System monitors / manages the electrical system
parts such as e.g.
– Batteries
– Heating
– Driver's door
– Wiring (broken wire, short circuit)
– Over-current of consumers
The switching levels and times depend on the
programming of the system.

Battery monitor / emergency-on mode

The battery monitor prevents the consumer battery from deep
discharging.
– Battery voltage < 11,3 V
(is defined by the vehicle manufacturer, usually 11.3 V)
– Warning and / or warning signal
– Consumers are switched off depending on the
programming
Corrective
– Charge battery
– Battery voltage < 10,8 V
– All consumers are switched off
– Warning message emergency-on mode possible
Corrective
– Charge battery, if necessary replace old battery.
If the battery voltage exceeds 12.5 V again, the consum-
ers are switched on again (depending on the program-
ming, only those with high priority or all consumers that were
active before the shut-down).
Emergency-on mode
If the shut-down feature has been triggered due to low cur-
rent (battery voltage < 10.8 V, delayed by e.g. 3 minutes),
the emergency-on mode can be activated for short-term
power supply to the consumers. The emergency-on mode is
switched on via the display or via a key depending on the fit-
tings in the vehicle.
In the emergency-on mode
– the system statuses are displayed
– the monitoring functions are activated
– the consumers are switched on again (depending on the
programming, only those with high priority or all consumers
that were active before the shut-down).
The emergency-on mode can also be activated several
times in succession as long as the battery voltage
is > 10 V.
20

Troubleshooting

Error
The Touch Panel does not
work.
Emergency-on mode is not
possible. (Battery voltage
< 10 V.
PIN input not possible.
If these measures do not solve the problem, please con-
tact the Truma Service Centre.

Technical data

Battery voltage
DC voltage 9 – 15.6 V
Current consumption at 12.5 V
max. 100 mA (Display 100 % brightness)
70 mA (Display 5 % brightness)
Protection class DIN EN 60529 (IEC 60529)
IP 22
Ambient temperature
-20 °C to +35 °C
Weigh
202 g
Touch Display
Size 4,3"
Resolution 480 x 256 Pixel
Declaration of conformity
The device satisfies the requirements of the following EC
Directives:
– End-of-Life Vehicle Directive 2000/53/EC
The device satisfies the requirements of the following UN ECE
regulations:
– Noise Suppression in Vehicles UN ECE R10 Type approval
number E1 10R -035550
The right to effect technical modifications is reserved!

Maintenance information

Clean the panel with a dry and fluff-free cloth.

Disposal

The device must be disposed of in line with the administrative
regulations of the respective land in which it is used. National
regulations and laws (e.g. in Germany the End-of-Life Vehicle
Ordinance) must be observed.
Rectification
Please contact the Truma
Service Centre of the respec-
tive service partner.
Charge battery, if necessary
replace old battery.
Order the Super-PIN from
the vehicle manufacturer.