Starting Up - Setting The Temperature; Frostmatic; Alarm Reset Button - AEG S 75348 KG Gebrauchsanweisung

Starting Up - Setting the Temperature

1. Plug the mains plug into the mains socket.
2. Press (A) button. The alarm light (M) flashes since the temperature is reached.
The buzzer sounds.
3. Pressing button (L) the buzzer stops.
4. Press either the (I) or (K) button. The temperature display switches over and
the DESIRED temperature currently set flashes on the temperature display.
5. Set the required temperature by pressing the (I) or (K) buttons (see section
"Temperature setting buttons"). The temperature display will immediately
show the changed setting. Each time the button is pressed the temperature is
adjusted by 1 °C.
From a food safety point of view -18 °C should be considered sufficiently cold
for storing food in the freezer.

FROSTMATIC

The FROSTMATIC function accelerates the freezing of fresh food and, at the
same time, protects foodstuffs already stored from undesirable warming.
1. The FROSTMATIC function is switched on by pressing the FROSTMATIC button
(H).
The yellow light (G) illuminates.
If the FROSTMATIC function is not ended manually, the appliance will switch
off the FROSTMATIC function after about 52 hours. The yellow light goes out.
2. The FROSTMATIC function can be ended manually at any time by pressing the
FROSTMATIC button again. The yellow light goes out.

Alarm reset button

In the event of an abnormal temperature rise inside the freezer (e.g. power
cut) warning light (M) will start to flash and a buzzer will sound. Push the
alarm reset button (L) to stop the buzzer sound, while the warning light will
continue to flash.
The buzzer will stop automatically when the temperature has returned to
normal while the warning light (M) will continue to flash. If we press the
alarm reset button (L) we stop the warning light and at the same time the
indicator show for about 5 seconds the warmest temperature reached in the
compartment.
52