Steps For Connecting In Access Point Mode Or Wired Lan Connection Mode; Connection Settings On The Projector - Epson EMP-7850 Installationshandbuch

Steps for Connecting in Access Point Mode or Wired LAN
Connection Mode
Caution :
• Do not unplug the power cable when EasyMP is in use (screens are changing or the
access lamp on the wireless LAN card is lit green).
• Do not remove the wireless LAN card when the access lamp on the wireless LAN card
is lit green, or when connected to a network. Doing so may damage the wireless LAN
card.
• For information about the Wired LAN card access lamp(s), refer to the documentation
of the Wired LAN card you are using.

Connection Settings on the Projector

First, set up the connection settings on the projector. Connection settings are found
on the Access point mode advanced settings screen or the Wired LAN connection
mode advanced settings screen of the Network Screen.
Modify these connection settings using the projector's remote control.
If these settings are already established, this step need not be performed.
Tip :
Apply the following settings under the direction of the network systems administrator.
Procedure
1 Insert the LAN card into the card slot on the projector.
See "Installation" for details.
2
Press the [Power] button on the remote control to turn the projector on.
p.14
41