Connecting Using Easy Connect Mode; Before Connecting - Epson EMP-7850 Installationshandbuch

Connecting Using Easy Connect Mode

This section describes the steps necessary to project images from a computer using
Easy connect mode, perform operations when projecting images, and to disconnect.
Perform the following steps prior to projecting images.
1. Set up the Easy connect mode settings on the projector.
2. Set up the connection on the computer.
3. Start EMP NS Connection on the computer, and connect to the network.
Once these settings have been established, future sessions can begin by just
connecting the devices. When connecting to a network for the first time or when
settings are changed, refer to "Connection Settings on the Projector" (
the projector and computer connection settings are already established, refer to
"Connecting to a Computer" (

Before Connecting

Ensure that the following procedures have been carried out before connecting a
computer and projector via a network.
• Install EMP NS Connections on the computer you will be using.
• Prepare the computer settings to use either a wireless LAN card or
internal wireless LAN functionality. Set the WEP
the documentation for the wireless LAN card installed in the computer, or
the computer's documentation.
• For optimal performance, set the screen resolution of the computer you
are using to XGA or lower with a colour depth of 16bit.
p.28 ).
p.22 ). If
p.17
to OFF. For setup, see
21