Front Panel - Pioneer DJM-S9 Bedienungsanleitung

The output signal level of DJM-S9 may be too high for some devices
connected to [MASTER 1] or [MASTER 2] terminal. If the sound of
the connected device is distorted, switch MASTER ATT to –6 dB or
–12 dB.
4 BOOTH output terminal
Output terminals for a booth monitor, compatible with balanced or
unbalanced output for a TRS connector.
5 CD/LINE input terminal
Connect to a DJ player or a line level output component.
6 PHONO input terminals
Connect to an analog player or other phono level (MM cartridge) out-
put device. Do not connect to a DJ player or other line level device.
To connect a device to the [PHONO] terminals, remove the short-
circuit pin plug inserted in the terminals.
Insert this short-circuit pin plug into the [PHONO] terminals when
nothing is connected to them to cut external noise.
WARNING
The short-circuit pin plugs out of the reach of children and infants. If
accidentally swallowed, contact a doctor immediately.
7 SIGNAL GND terminal
Connects an analog player's ground wire here. This helps reduce
noise when the analog player is connected.

Front panel

3 4
6
1 PHONES jacks
Connect headphones here.
This product supports 1/4" stereo phone plugs and 3.5 mm stereo
mini plugs.
2 CROSS FADER CURVE adjustment control
Adjusts the crossfader curve characteristics.
3 MIC ON OFF selector switch
Turns the microphone on/off.
4 MIC TALK OVER selector switch
Turns on and off the talk-over function while the microphone is
turned on.
5 MIC indicator
Turns on and off the talk-over function while the microphone is
turned on.
— While the MIC is off: The light is off.
— While the MIC is on: The light is on.
5 8
7 9
8 MIC input terminals
Connects a microphone here.
9 MIC input level selector switch
— [MIC]: Select this when connecting the microphone to the [MIC]
terminal.
— [LINE]: Select this when connecting line level output devices to
the [MIC] terminal.
a Kensington security slot
b
USB terminal
Connect to a computer.
c POWER switch
Turns this unit's power on and off.
d AUX input terminal
Connect to the output terminal of an external device (sampler, por-
table audio device, etc.)
e AC IN
Connects to a power outlet using the included power cord. Wait until
all connections between the equipment are completed before con-
necting the power cord.
Be sure to use the included power cord.
a b
c d d c
— While talking over: The light blinks.
6 MIC LEVEL control
Adjusts the level of the sound output from the [MIC] channel.
7 MIC EQ (HI, LOW) control
Adjusts the sound quality of the [MIC] channel.
8 MIC ECHO control
Adjusts the parameter of echo effect applied to the [MIC] channel.
9 AUX LEVEL control
Adjusts the level of the sound input to the AUX channel.
a CROSS FADER FEELING ADJUST control
This can be used to adjust the crossfader's operating load.
b CROSS FADER REVERSE switch
Turns the crossfader reverse function on and off.
2 1 e
11
En