Connection Diagram For Standard Mode Without Internal Amp - Pioneer DEH-P88RS Installationsanleitung

Connecting the Units

Connection diagram for standard mode without internal amp

Note:
• If using this system, we recommend that this unit's internal amp is turned off.
For more details, refer to operation manual.
Antenna jack
Power cable
(For details, refer to page 3 to 4.)
7
This product
DSP switch
Switch the DSP switch as
illustration below.
Blue/white
To system control terminal of the power
amp (max. 300 mA 12 V DC).
Blue/white (7*)
To Auto-antenna relay control
terminal (max. 300 mA 12 V DC).
Speaker leads
Not used.
Blue/white (6*)
ISO connector
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
30 cm
15 cm
15 cm