Problem Solving - Philips SBCVL1100/00 Bedienungsanleitung

Problem
No picture on TV2
Bad picture/sound
quality on TV2
The cable
programme you
are watching
disappears after
several minutes
Wrong picture on
TV2

Problem solving

If a fault occurs, first check the points listed below. If you are unable to
remedy a problem by following these hints, contact the helpline
(see 'Need help?') or consult your dealer.
Never try to open the set yourself as this will void the guarantee.
First, check all cables to ensure that they are connected correctly.
Solution
• Ensure that both units are switched on
(both green power lights (1 and 9) are lit).
• Select the EXT or AV channel on TV2.
• Activate the video source you would like to watch
(set-top box: power on;VCR/DVD: playback).
• Select the same channel on the receiver and transmitter units,
using CHANNEL switches 6 and 14.
• If a VCR is used as the video source, ensure that the correct
SCART connector of the VCR is being used.
(Ext. 1 or Ext. 2. Check VCR User Manual).
• Move the receiver unit around on the surface it is positioned on,
centimetre by centimetre until you get good picture and sound quality.
• Carry out the same procedure for the transmitter unit.
• Change both units to another frequency channel, using CHANNEL
switches 6 and 14.
Make sure that both units use the same frequency channel.
• Reduce the distance between the transmitter and receiver units
(less than 30 metres).
• Disable the auto standby mode of the VCR. (Check VCR's User Manual).
• Select the EXT or AV channel on TV2
• Activate the video source you would like to watch
(set-top box: power on;VCR/DVD: playback).
• It is possible that a signal from another Wireless TV Link is being picked
up. Switch to another channel on both units,
using CHANNEL switches 6 and 14 to receive your own signal.
Make sure that the same channel is selected on both units!
ENGLISH
11