Filling The Water Reservoir; Switching On The Machine - Philips Senseo HD7854/60 Bedienungsanleitung

- Remove used coffee pods directly after brewing.
- Rinse the milk container unit after you have brewed a cappuccino, latte
macchiato or caffè latte with the CLEAN button (see section 'Rinsing
after every use' in chapter 'Cleaning the milk container unit').
- Clean the milk container and the lid thoroughly if you are not going
to use the milk container again that day (see section 'Cleaning all parts
after the last use of the day' in chapter 'Cleaning the milk container
unit').
- If you have not used the coffee machine for some time, flush the
machine before you use it again (see section 'Flushing the coffee
machine in chapter 'Cleaning the machine') with fresh water before you
use it again.

Filling the water reservoir

1 Fill the water reservoir with cold water to a level above the MIN
indication and place it back onto the machine.
The MIN indication indicates the minimum amount of water required for
brewing coffee. Always fill the water reservoir beyond the MIN level.
Never pour milk, coffee, hot water or carbonated water into the water
reservoir.

Switching on the machine

1 Put the plug in an earthed wall socket.
2 Press the on/off button 3.
The light ring light flashes slowly while the water is heating up.
,
Heating up takes approx. 90 seconds.
The coffee machine is ready for use when the light ring around the
,
on/off button lights up continuously.
If the light ring around the on/off button flashes rapidly, the water
,
reservoir does not contain enough water for brewing coffee.
Placing a pod holder
1 Move the lid lever upwards to release the lid.
2 Open the lid.
3 Place the appropriate pod holder in the machine.
Note: You can only brew 2 cups at the same time if you brew SENSEO
coffee.
ENGLISH
11
black
®